Connectors

PRODUCT ID:142

RP-SMA female connector, 50ohm. Edge mountable/solderable for standard 1.6mm thick PCBs. For use with MoteinoMEGA, MightyHat or any other RF...

$2.50

In Stock

SMA female (4-point)

PRODUCT ID:194

Straight 4-point mount SMA female connector, 50ohm. The 4 mounting points are in a 0.2" (5.08mm) grid. Center feed pin is 0.9mm thick, recommended...

$2.50

In Stock

SMA female connector (1.2mm)

PRODUCT ID:191

Edge mount SMA female connector, 50ohm. Recommended for PCB thicness of 1.2mm, such as all the Moteino boards. Cannot be mounted on...

$2.50

In Stock

SMA female connector (1.6mm)

PRODUCT ID:141

Edge mount SMA female connector, 50ohm. Recommended for standard PCB thicness of 1.6mm, such as: - MightyHat - PCB Dipole Antenna Could...

$2.50

In Stock

SMA female RA (4-point)

PRODUCT ID:195

Right angled 4-point mount SMA female connector, 50ohm. The 4 mounting points are in a 0.2" (5.08mm) grid. Center feed pin is 0.9mm thick, recommended...

$2.50

In Stock

SMA male connector

PRODUCT ID:188

SMA male connector, 50ohm. Edge mountable/solderable for standard 1.6mm thick PCBs. Can be mounted on all Moteino boards as well as the dipole...

$2.95

Only 23 left

Lithium Ion Polymer Battery 3.7v 1200mAh

PRODUCT ID:200

Lithium Ion Polymer Battery 1200mAh output at 3.7v nominal 4.2V when fully charged includes protection circuitry (over...

Lithium Ion Polymer Battery 1200mAh output at 3.7v nominal 4.2V when fully charged includes protection circuitry (over charging, overload) JST PH2.0 connector mating with JST connectors in all our battery powered products like CurrentRanger, MoteinoM0, as well as virtually all such battery powered boards at other vendors dimensions: 1.75*1.5", 0.26" thick (45*37mm, 6.7mm thick) 50mm lead length 28g (1oz) Important notes...

$9.95

Only 21 left

3-pin Screw Terminals

PRODUCT ID:107

3-pin Screw Terminals 5.08mm pin spacing. Datasheet & drawing: http://www.on-shore.com/sites/default/files/manuals/osttcxx2162.pdf

$0.95

Out of Stock

9V Battery Clip

PRODUCT ID:140

This is a simple 9V battery clip with solderable/breadboardable wires and a durable plastic housing. Dimensions: 23.3x7.3x12mm Wires: 15cm...

$0.95

Out of Stock

Banana to Hook Test Clip Cables - 40"

PRODUCT ID:183

Blue/Red pair of flexible silicone rubber cable - banana plug to hook clip. Having good cables with low resistance is essential for accurate measurements...

$9.95

Out of Stock

Battery connector - 2mm JST

PRODUCT ID:168

JST connector, 2pin / 2mm pitch. Can be used to connect battery packs or leadless LiPo batteries to projects Power various boards that...

JST connector, 2pin / 2mm pitch. Can be used to connect battery packs or leadless LiPo batteries to projects Power various boards that have the mating JST 2mm pitch connector (watch for polarity!) 100mm total length including connector Mates with JST 2 pin connector found on many boards that typically require Lithium Polymer batteries If you need to reverse polarity it can be done by carefully pulling each crimped connector from the housing (lift the small tab above...

$1.95

In Stock

DC Power Jack

PRODUCT ID:95

Standard 2.1mm DC power jack, same as the one on the Arduino UNO/Duemilanove. It's also an INPUT option on the ATXRaspi.

$1.95

Only 6 left

u.FL connector

PRODUCT ID:153

u.FL RF connector (50ohm) Can be soldered to Moteino (R5+), MoteinoMEGA, MightyHat.

$0.95

Out of Stock

USB-A to MicroB cable (6")

PRODUCT ID:92

Flexible 6" USB cable (A-microB). Total length from end to end including connectors is 6.5" (~162mm). Can be used with all the LowPowerLab USB based...

$3.95 $1.95

Out of Stock

USB-A to USB-C cable (10")

PRODUCT ID:201

Flexible 6" USB cable (USB-A to USB-C). Total length from end to end including connectors is 6" (~15cm). Can be used with LowPowerLab USB based products...

$3.95

In Stock