AtxRaspi and different button.

[mheyman]

Hey I want to use a separate button and LED to use ATXraspi. The LED setup is simple enough.

How would I got about wiring this button as the button? http://www.arcadeshop.de/Special-Mini-Minibutton-SDM-20-black_856.html

Does it matter which side is wired to which pin?

[Felix]

It should work just fine as long as it's a momentary button (not a latching button).
It does not matter which way you connect the 2 pins.
You can use any momentary tactile or similar button like that. The LED is where you will have to solder the + side correctly for your LED, and no resistor is needed (a 220ohm is already onboard).

[TCMOrangeJoe]

Hi, sorry for posting in an old thread, but would I be able to use this button?
http://bit.ly/23rGAVs

[Felix]

It's a latching type so no... they usually offer the non-latching (momentary) version as well. That's what you need, ie a switch that does not latch when you push it, but comes back fully.
I think this one should work. Sometimes with china it's a gamble, they say one thing in the description and you get the wrong item. It happened to me many times. But it's worth a try if you want a custom color or size...
In my store I offer green ring 16mm chrome momentary buttons like that.

[TCMOrangeJoe]

Oh, sorry. All of the other ones like it were momentary, I didn't notice that one latched. Thanks. I was just curious about the voltage not being enough. There are a lot of auto shops around here, so I'm gonna check there first.

[Felix]

The ones I get are 12V rated yet the 5v from ATXRaspi gives the ring a nice not too bright glow.

[TCMOrangeJoe]

Thanks for the help