ATX Raspi Rocker Switch

[20UMLEE]

Hi, I am trying to use the ATX Raspi 3 with a Rocker Latching Switch instead of the momentary switch. The website states to "Solder this Jumper on reversal" but it does not state where to solder to. A clarification on what points to solder would be greatly appreciated.

[sparky]

On the backside of the board you will see two copper pads, silkscreen "Latching BTN", that you need to jumper with some solder when using a latching type switch.

[Felix]

Thanks sparky.

"Solder this Jumper on reversal" nowhere to be found on this website except in this thread 

I guess I didn't do a good enough job by using words and pictures 

https://lowpowerlab.com/guide/atxraspi/features/
https://lowpowerlab.com/guide/atxraspi/assembly-install/

[sparky]

He must have took your exclamation mark as an L in the picture he posted where you state "Solder this jumper on reverse!"

[Felix]

There's even an arrow there. 

[20UMLEE]

Wow, Sorry guys I now realize that it was simply jumping the connectors. It was a long day haha