Hi, I am trying to use the ATX Raspi 3 with a Rocker Latching Switch instead of the momentary switch. The website states to "Solder this Jumper on reversal" but it does not state where to solder to. A clarification on what points to solder would be greatly appreciated.
On the backside of the board you will see two copper pads, silkscreen "Latching BTN", that you need to jumper with some solder when using a latching type switch.
Thanks sparky.
"Solder this Jumper on reversal" nowhere to be found on this website except in this thread ???
I guess I didn't do a good enough job by using words and pictures :'(
https://lowpowerlab.com/guide/atxraspi/features/
https://lowpowerlab.com/guide/atxraspi/assembly-install/
He must have took your exclamation mark as an L in the picture he posted where you state "Solder this jumper on reverse!"
There's even an arrow there. :D
Wow, Sorry guys I now realize that it was simply jumping the connectors. It was a long day haha