Print Page - Gateway Moteino not sending command to SwitchMote [solved]

Title: Gateway Moteino not sending command to SwitchMote [solved]
Post by: mario.almeida on February 05, 2017, 10:45:13 AM

Hi All,

Setup:
Pi2, MoteinoUSB and SwitchMote 2x10A. Both Moteino have no flash. RFM69HW 868M

Image installed from here -> https://drive.google.com/file/d/0B89HtwH5i2d0S01jTFk3aDgxNTA/view as instructed here https://lowpowerlab.com/guide/gateway/?view=all.

I am using Gateway and SwitchMote code from RFM69 examples. Only changed the NETWORKID to 250 and ENCRYPTKEY.

SwitchMote is registered and shown in the gateway UI. ON/OFF action on SwitchMote is reflected in the gateway UI, but no action from the gateway UI is sent to SwitchMote and in the log file I have this entry

Quote[LOG] NODEACTION: {"nodeId":10,"action":"BTN0:0"}

:'(

Any configuration that I have missed?

Title: Re: Gateway Moteino not sending command to SwitchMote
Post by: mario.almeida on February 06, 2017, 04:12:51 AM

Hi All,

Can someone help me in this?

Title: Re: Gateway Moteino not sending command to SwitchMote
Post by: Felix on February 06, 2017, 08:13:23 AM

Hi Mario,

Make sure you have the PiGateway (https://github.com/LowPowerLab/RFM69/blob/master/Examples/PiGateway/PiGateway.ino) sketch on your Pi.
Also make sure you configure the IS_RFM69HW parameter in the sketches according to each of your RFM69, match frequency and network ID, etc.

FWIW You only need the FLASH MEM if you plan to use wireless programming, which would be recommended for SwitchMote once wired to mains.

Title: [SOLVED] Gateway Moteino not sending command to SwitchMote
Post by: mario.almeida on February 06, 2017, 12:03:38 PM

Thanks Felix, I had the Gateway sketch instead of PiGateway ;D

LowPowerLab Forum

Software support => Pi Gateway => Topic started by: mario.almeida on February 05, 2017, 10:45:13 AM