Motion Kit

[stern0m1]

Is it normal with the motion kit that even when the switch is in the off position there is still some voltage. I'm getting like 2 volts even with it off.

[Felix]

Is it normal with the motion kit that even when the switch is in the off position there is still some voltage. I'm getting like 2 volts even with it off.

Still some voltage where?

[stern0m1]

3.3v pin on a moteino connected to the motionmote board.

[Felix]

What I see on a MotionMote here is after turning it off (and unconnected to anything) the GND-3.3V shows a drop from 0.7v to around 0.4v and slowly ramping down from there.

[stern0m1]

By me with the battery disconnected is goes to zero but with the battery in and the switch off it still reads 2 volts.
Is that a bad switch?
Thanks

[Felix]

Possibly. Just verify if its a bad switch with your continuity meter (no battery).