Author Topic: Old Skool NES case use ATX power with it?  (Read 1624 times)

Raymond Day

  • NewMember
  • *
  • Posts: 4
Old Skool NES case use ATX power with it?
« on: May 09, 2017, 10:13:31 PM »
Can buy this nice NES Case at Amazon for $20.

It does have a hole for a LED but the power and reset I guess could cut them out to use them like a power and reset with the ATX power?

If so how can wire up 2 switches one for power and one for reset. Can you do that with the ATX power?

-Raymond Day

Felix

  • Administrator
  • Hero Member
  • *****
  • Posts: 6866
  • Country: us
    • LowPowerLab
Re: Old Skool NES case use ATX power with it?
« Reply #1 on: May 10, 2017, 10:36:26 AM »
All wiring is explained in the guide.
Here's the wiring for [latching power] + [reset] buttons:



Raymond Day

  • NewMember
  • *
  • Posts: 4
Re: Old Skool NES case use ATX power with it?
« Reply #2 on: May 22, 2018, 06:28:04 AM »
That's good they have this option! Thanks for posting it.

Felix

  • Administrator
  • Hero Member
  • *****
  • Posts: 6866
  • Country: us
    • LowPowerLab
Re: Old Skool NES case use ATX power with it?
« Reply #3 on: May 22, 2018, 08:45:13 AM »
The latching option 10K resistor has now been added to the board and you only need to solder a solder bridge on the bottom of the PCB (starting with R2.8).
For the reset you can also do that same as in the photo.