Text only | Text with Images

LowPowerLab Forum

Hardware support => ATXRaspi => Topic started by: Raymond Day on May 09, 2017, 10:13:31 PM

Title: Old Skool NES case use ATX power with it?
Post by: Raymond Day on May 09, 2017, 10:13:31 PM
Can buy this nice NES Case at Amazon for $20. (http://amzn.to/2q3OHth)

It does have a hole for a LED but the power and reset I guess could cut them out to use them like a power and reset with the ATX power?

If so how can wire up 2 switches one for power and one for reset. Can you do that with the ATX power?

-Raymond Day
Title: Re: Old Skool NES case use ATX power with it?
Post by: Felix on May 10, 2017, 10:36:26 AM
All wiring is explained in the guide (https://lowpowerlab.com/guide/atxraspi/assembly-install/).
Here's the wiring for [latching power] + [reset] buttons:

(https://lowpowerlab.com/wp-content/uploads/2016/09/ATXRaspi_GPIO_latching_with_reset2.png)
Title: Re: Old Skool NES case use ATX power with it?
Post by: Raymond Day on May 22, 2018, 06:28:04 AM
That's good they have this option! Thanks for posting it.
Title: Re: Old Skool NES case use ATX power with it?
Post by: Felix on May 22, 2018, 08:45:13 AM
The latching option 10K resistor has now been added to the board and you only need to solder a solder bridge on the bottom of the PCB (starting with R2.8).
For the reset you can also do that same as in the photo.
Text only | Text with Images