Hello!
I have two questions. I want to hook up a momentary button for the switch and also use an LED (https://www.adafruit.com/products/299 (https://www.adafruit.com/products/299)). Is a 200ohm resistor enough to wire the LED to the pcb?
Also I was wondering if it was ok to install the script before setting up the ATXRaspi. I might not have internet access at the time of installation and was wondering if I could get that out of the way beforehand.
Thanks!
THere is already a 220 ohm resistor on the ATXRaspi for the LED.
You can install the script but it will likely restart or shut down your Pi since the Pin is left unconnected and floating and bound to pick up a HIGH signal. So I really don't recommend it.
Please follow the guide/video at lowpowerlab.com/atxraspi and that's the only step-by-step I can recommend.