I did commands like this:
cd /home
wget https://raw.githubusercontent.com/LowPowerLab/ATX-Raspi/master/shutdownchecksetup.sh
chmod 777 /home/shutdownchecksetup.sh
nano /home/shutdownchecksetup.sh
Then changed 2 lines like this:
SHUTDOWN = 6 #GPIO used for shutdown signal
BOOT = 12 #GPIO used for boot signal
The 6 and 12 changed.
CTRL O to WriteOut and CRTL X to Exit.
Then ran it with:
/home/shutdownchecksetupsh
It had 3 options I picked 1.
1 Install INTERRUPT based script /etc/shutdownirq.py (recommended)It works now! I tested it out and now can reset and turn it off with the switch.
So this my help others to know how to switch were the GPIO pins go.
It just installed it again with that script and I edit the script GPIO pin number before I ran it.
-Raymond Day