LowPowerLab Forum
Hardware support => ATXRaspi => Topic started by: Joiyco on April 13, 2021, 12:36:26 PM
-
Hi there!
I have found an old ATXRaspi R2.6 in the basement from a old Project and want to reuse it.
Ist there are way to modify the R2.6 for software shutdown Like discribed Here for the R3(https://lowpowerlab.com/guide/atxraspi/full-pi-poweroff-from-software/)
Best regards,
Joi
-
I think I found the solution in the Blog
(https://lowpowerlab.com/2016/12/29/atxraspi-full-power-off-from-software/)
There is a Transistor and the a 10k resistor which ist Missing on the R2.6 PCB but it is included on the R3 Board.
I brought a Transistor Set and Test it tomorrow.
Best regards
Joi