LowPowerLab Forum

Hardware support => ATXRaspi => Topic started by: tonyp7 on January 03, 2017, 01:58:22 AM

Title: Completed my little pet project: The Playstation Pi
Post by: tonyp7 on January 03, 2017, 01:58:22 AM

https://idyl.io/playstationpi

(https://idyl.io/wp-content/uploads/2016/12/all-inside.jpg)

Specifically: usage of the ATXRaspi: https://idyl.io/playstationpi/playstationpi-power-handling/

So well thanks Felix for this little board! It's also spawned a sub project where I'll just make my own board with an attiny44 as I'd like more functionalities (reset button, latch power button, auto power off when the boot signal is lost to name them)

Title: Re: Completed my little pet project: The Playstation Pi
Post by: Felix on January 03, 2017, 09:43:08 AM

Tony,
Very nice project!
The good news is that there is now a new R2.7 revision which supports everything for such projects including latching power button, separate reset button, and software shutdown.
This has just started shipping and I have to publish the official release notes, although the details are already available:

https://lowpowerlab.com/guide/atxraspi/assembly-install/
https://lowpowerlab.com/guide/atxraspi/full-pi-poweroff-from-software/

(https://lowpowerlab.com/wp-content/uploads/2016/09/ATXRaspi_GPIO_latching_with_reset2.png)
(https://lowpowerlab.com/wp-content/uploads/2016/12/ATXRaspi_GPIO_software_shutdown.png)

Title: Re: Completed my little pet project: The Playstation Pi
Post by: tonyp7 on January 03, 2017, 11:03:21 PM

Hey Felix,

Does that mean I have to update the firmware of the 2.6 as well? If so, do you provide the HEX file?

Thanks!

Title: Re: Completed my little pet project: The Playstation Pi
Post by: Felix on January 04, 2017, 08:15:47 AM

I can do it for you at no charge or I can send you the HEX, email me for that.

Title: Re: Completed my little pet project: The Playstation Pi
Post by: tonyp7 on January 05, 2017, 09:57:07 PM

Well you were nice enough to include ISP headers on your board design so I'm sure I can upload the hex file myself ;-)

email in pm!