Finally my long awaited case build
Here is my raspberry pi case I made out of a Star Wars Galactic Heroes Millennium Falcon. (Don't mind all the wiring it is still unfinished and will get all organized)
I installed led's in the front and in the satellite dish to the Pi so it flashes when its active. I did this by following Eazy Hax video. I also added a blue led strip to the back to create the effect its engines are fired up. I gutted out the inside so I can fit the RP3, HDD, fan and the ATXRASPI. I drilled holes into the top "vents" so the fan I installed can blow out the hot air. I cutout the side to fit in a dual usb plug so I don't have to keep on opening it up. The power button is controlled by the ATXRASPI to shutdown or reboot the RP3.
Just have the rainbow cube to figure out......
https://youtu.be/pssKlufrXT0
Nice, not lol at all :)
Hey I think your shutdown script is not running, that's why you have to do a forced shutdown (LONG hold).
Also I see other lights and stuff taht I assume are feeding from the ATXRaspi...that might be a cause for the rainbow if the load is too high although ATXRaspi can handle a very hefty load without issues. Again great wiring and soldering is essential.
Check the shutdown script, make sure it runs so you can properly shutdown/reboot. If it runs properly the "BOOTOK" green LED will be green once Pi fully boots.
Lights are connected to the gpio pins and I had those installed with an HDD with no rainbow square. It wasn't until I installed the ATXRASPI then I got the rainbow square. For some reason that was the only time I had to long press to turn it off, it turns off like it should now.
Maybe you hadn't restarted after installing the shutdown script?
Anyway sounds like that is solved.