Author Topic: Mote Terminal Interface  (Read 963 times)


  • Full Member
  • ***
  • Posts: 176
Mote Terminal Interface
« on: March 14, 2015, 05:17:31 AM »
So I previously mentioned the UniMote idea: one sketch to rule them all. Serial and RF control, reconfiguration, and polling of nodes, remote and local. I recently updated the post:

Blurged about it here:

More important, I created a web UI for sending commands to motes. When setting up a network of nodes for multiple IO configurations, all I have to is pop on the the UI from my gateway.

In the screen cap below, you can see I'm sending a command to node 10, telling it to report its config parameters back to node 1 (the gateway).

Link here:

« Last Edit: March 16, 2015, 01:09:24 PM by ColinR »
CuPID Controls :: Open Source browser-based sensor and device control