SX126X New Lora Semtech products

[SadE54]

Hi ,

I found this a few days ago :
https://www.semtech.com/products/wireless-rf/lora-transceivers/sx1262

LoRa and FSK Modem
170 dB maximum link budget (SX1262 / 68)
+22 dBm or +15 dBm high efficiency PA
Low RX current of 4.6 mA
Integrated DC-DC converter and LDO
Programmable bit rate up to 62.5 kbps LoRa and 300 kbps FSK
High sensitivity: down to -148 dBm
88 dB blocking immunity at 1 MHz offset
Co-channel rejection of 19 dB in LoRa mode
FSK, GFSK, MSK, GMSK and LoRa modulation
Built-in bit synchronizer for clock recovery
Automatic Channel Activity Detection (CAD) with ultra-fast AFC
4mm x 4mm

It looks nice , I cannot wait to see some products using it !

[LukaQ]

Would you need long range, how about two way comm, would it be battery powered for long time? How often would be data send?
if not, there are still better tech. then this

[Felix]

This is just the transceiver chip, some modules would need to be made by someone (hopeRF?) and then someone else would need to invest the time to write and test libs etc.
Seems like a lot of the RF stuff is similar to the SX1276 chips on the existing LoRa modules?

[SadE54]

it seems the product line will be released in march . I'm pretty sure our Chinese friends are already working on new boards for sx126x...
The protocol/registers will be probably the same than current Lora products. It's in their best interest for an effective integration of the new line.
Personally  , 4.6mA (almost 50% less) and 20% of added range could improve a lot energy management for bidirectional communication!

[SadE54]

Official docuements are available since today :
https://www.semtech.com/products/wireless-rf/lora-transceivers/sx1262