Hi,
i tested the ATX RASPI without the Display, all things go fine. The Power LED of the switch turned off. All LED on the ATX Board go dark, power off. I can power on again.
But when i connect the Raspberry 7" Display, i get no flashing flash in the corner, all go wrong.
- I can start only when i connecting "fresh Power input", i mean the "first Time" ;-)
- I can inital the shutdown .... but The grenn light on the ATX still on. After a minute all LED on the board gets very dark, but still on. The LED from Switch is still on.
i can´t power on again.
Any hints ?
Sorry for my bad english, hope you understood me.
Walli
SOLVED !!!
I must use the phyton script. Now all work fine.
I used Volumio, so i installed RPi.GPIO first. (https://zasieczny.wordpress.com/2015/02/12/volumio-installing-gpio-python-module-to-control-amplifier/)
Now i can use the Phyton Script and all things going well.
Thx
Walli
Great, thanks for the update.
BUZERSOUND ....
It worked for 1 time :(
Any hints
Walli
It must be some software problem. Since it worked one time, it means the board can receive signals from the Pi and can issue a shutdown.
Is it possible to try it on a raspbian just to verify?